openwrt/target/linux/ath79
Ryan Mounce 35aecc9d4a ath79: add support for WD My Net N600
SoC: AR9344
RAM: 128MB
Flash: 16MiB SPI NOR
5GHz WiFi: AR9382 PCIe 2x2:2 802.11n
2.4GHz WiFi: AR9344 (SoC) AHB 2x2:2 802.11n

5x Fast ethernet via SoC switch (green LEDs)
1x USB 2.0
4x front LEDs from SoC GPIO
1x front WPS button from SoC GPIO
1x bottom reset button from SoC GPIO

UART header JP1, 115200 no parity 1 stop
TX
GND
VCC
(N/P)
RX

Flash factory image via "emergency room" recovery:
- Configure your computer with a static IP 192.168.1.123/24
- Connect to LAN port on the N600 switch
- Hold reset putton
- Power on, holding reset until the power LED blinks slowly
- Visit http://192.168.1.1/ and upload OpenWrt factory image
- Wait at least 5 minutes for flashing, reboot and key generation
- Visit http://192.168.1.1/ (OpenWrt LuCI) and upload OpenWrt sysupgrade image

Signed-off-by: Ryan Mounce <ryan@mounce.com.au>
[dt leds preparations]
Signed-off-by: Christian Lamparter <chunkeey@gmail.com>
2021-12-11 00:50:02 +01:00
..
base-files/etc/hotplug.d/ieee80211 ath79: add WiFi migration for AR913x 2020-09-28 16:23:03 +02:00
dts ath79: add support for WD My Net N600 2021-12-11 00:50:02 +01:00
files ath79: ag71xx: Disable napi related interrupts during probe 2021-10-23 18:50:31 +02:00
generic ath79: add support for WD My Net N600 2021-12-11 00:50:02 +01:00
image ath79: add support for WD My Net N600 2021-12-11 00:50:02 +01:00
mikrotik Revert "ath79: add support for Mikrotik LHG 5" 2021-11-23 00:45:39 +01:00
nand ath79: add support for Netgear R6100 2021-11-03 12:45:40 +01:00
patches-5.4 kernel: bump 5.4 to 5.4.161 2021-11-28 16:32:45 +01:00
patches-5.10 kernel: bump 5.10 to 5.10.80 2021-11-19 09:40:29 +00:00
tiny ath79: consolidate testing kernel 2021-04-10 19:28:04 +02:00
config-5.4 ath79: add missing MTD_NAND_RB91X symbol 2021-07-09 17:11:12 +02:00
config-5.10 kernel: 5.10: packet mangling code only for ar8216 driver 2021-11-02 22:36:41 +01:00
Makefile ath79: consolidate testing kernel 2021-04-10 19:28:04 +02:00
modules.mk