mirror of
https://github.com/openwrt/openwrt.git
synced 2024-12-27 09:12:39 +00:00
c6ddf8d502
Many changes were done in drivers/pinctrl/bcm/pinctrl-bcm2835.c between
5.4.171 and 5.4.179.
The following 3 patches do not apply any more:
* target/linux/bcm27xx/patches-5.4/950-0316-pinctrl-bcm2835-Add-support-for-BCM2711-pull-up-func.patch
This was already integrated in kernel v5.4-rc1, it was never needed.
* target/linux/bcm27xx/patches-5.4/950-0328-Revert-pinctrl-bcm2835-Pass-irqchip-when-adding-gpio.patch
* target/linux/bcm27xx/patches-5.4/950-0362-pinctrl-bcm2835-Change-init-order-for-gpio-hogs.patch
I think these were done to fix the problem which was really fixed in
commit 75278f1aff5e ("pinctrl: bcm2835: Change init order for gpio
hogs") from v5.4.175
target/linux/generic/backport-5.4/716-v5.5-net-sfp-move-fwnode-parsing-into-sfp-bus-layer.patch
Move fwnode_device_is_available to the same position as in kernel 5.10.
target/linux/layerscape/patches-5.4/302-dts-0083-arm64-ls1028a-qds-correct-bus-of-rtc.patch
Applied in commit 65816c1034769e714edb70f59a33bc5472d9e55f ("arm64: dts:
ls1028a-qds: move rtc node to the correct i2c bus")
Compile-tested: lantiq/xrx200, bcm27xx/bcm2710
Run-tested: lantiq/xrx200
Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de>
|
||
|---|---|---|
| .. | ||
| 0001-v5.7-spi-make-spi-max-frequency-optional.patch | ||
| 0002-v5.7-spi-add-support-for-mediatek-spi-nor-controller.patch | ||
| 0003-switch-add-mt7531.patch | ||
| 0005-dts-mt7622-add-gsw.patch | ||
| 0005-dts-mt7629-add-gsw.patch | ||
| 0006-dts-fix-bpi2-console.patch | ||
| 0006-dts-fix-bpi64-console.patch | ||
| 0010-dts-mt7629-rfb-fix-firmware-partition.patch | ||
| 0226-phy-phy-mtk-tphy-Add-hifsys-support.patch | ||
| 0227-arm-dts-Add-Unielec-U7623-DTS.patch | ||
| 0301-mtd-mtk-ecc-move-mtk-ecc-header-file-to-include-mtd.patch | ||
| 0303-mtd-spinand-disable-on-die-ECC.patch | ||
| 0306-spi-spi-mem-MediaTek-Add-SPI-NAND-Flash-interface-dr.patch | ||
| 0307-dts-mt7629-add-snand-support.patch | ||
| 0308-dts-mt7622-add-snand-support.patch | ||
| 0310-dts-add-wmac-support-for-mt7622-rfb1.patch | ||
| 0500-v5.6-crypto-backport-inside-secure.patch | ||
| 0501-crypto-add-eip97-inside-secure-support.patch | ||
| 0502-dts-mt7623-eip97-inside-secure-support.patch | ||
| 0503-crypto-fix-eip97-cache-incoherent.patch | ||
| 0600-net-phylink-propagate-resolved-link-config-via-mac_l.patch | ||
| 0601-net-dsa-propagate-resolved-link-config-via-mac_link_.patch | ||
| 0602-net-dsa-mt7530-use-resolved-link-config-in-mac_link_.patch | ||
| 0603-net-dsa-mt7530-Extend-device-data-ready-for-adding-a.patch | ||
| 0604-net-dsa-mt7530-Add-the-support-of-MT7531-switch.patch | ||
| 0605-arm64-dts-mt7622-add-mt7531-dsa-to-bananapi-bpi-r64-board.patch | ||
| 0900-bt-mtk-serial-fix.patch | ||
| 0990-gsw-rtl8367s-mt7622-support.patch | ||
| 0991-dt-bindings-PCI-Mediatek-Update-PCIe-binding.patch | ||
| 0992-PCI-mediatek-Use-regmap-to-get-shared-pcie-cfg-base.patch | ||
| 0993-arm64-dts-mediatek-Split-PCIe-node-for-MT2712-MT7622.patch | ||
| 0994-ARM-dts-mediatek-Update-mt7629-PCIe-node.patch | ||
| 1003-dts-mt7622-rfb-change-to-ax-mtd-layout.patch | ||
| 1010-pcie-mediatek-fix-clearing-interrupt-status.patch | ||
| 1011-net-ethernet-mtk_eth_soc-add-support-for-coherent-DM.patch | ||
| 1012-pci-pcie-mediatek-add-support-for-coherent-DMA.patch | ||
| 1020-spi-nor-w25q512jv.patch | ||
| 1021-ubnt-ledbar-driver.patch | ||