mirror of
https://github.com/openwrt/openwrt.git
synced 2024-12-19 05:38:00 +00:00
5572e0196a
TP-Link CPE710-v2 is an outdoor wireless CPE for 5 GHz with one Ethernet port based on the AP152 reference board. Compared to the CPE710-v1, the only change observed in hardware is that the mdio address of the ethernet physical changed from 0x4 to 0x0. Specifications: - SoC: QCA9563-AL3A MIPS 74kc @ 775MHz, AHB @ 258MHz - RAM: 128MiB DDR2 @ 650MHz - Flash: 16MiB SPI NOR Based on the GD25Q128 - Wi-Fi 5Ghz: ath10k chip (802.11ac for up to 867Mbps on 5GHz wireless data rate), based on the QCA9896 - Ethernet: one 1GbE port - 23dBi high-gain directional 2×2 MIMO parabolic antenna - Power, LAN, WLAN5G Blue LEDs Flashing instructions: Flash factory image through stock firmware WEB UI or through TFTP To get to TFTP recovery just hold reset button while powering on for around 30-40 seconds and release. Rename factory image to recovery.bin Stock TFTP server IP:192.168.0.100 Stock device TFTP address:192.168.0.254 Signed-off-by: Tim Noack <tim@noack.id> Link: https://github.com/openwrt/openwrt/pull/16637 Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> |
||
|---|---|---|
| .. | ||
| base-files/etc/hotplug.d/ieee80211 | ||
| dts | ||
| files | ||
| generic | ||
| image | ||
| mikrotik | ||
| nand | ||
| patches-6.6 | ||
| tiny | ||
| config-6.6 | ||
| Makefile | ||
| modules.mk | ||