Sven Eckelmann 1699c1dc7f ath79: Add support for OpenMesh OM5P-AC v2 ... Device specifications: ====================== * Qualcomm/Atheros QCA9558 ver 1 rev 0 * 720/600/200 MHz (CPU/DDR/AHB) * 128 MB of RAM * 16 MB of SPI NOR flash - 2x 7 MB available; but one of the 7 MB regions is the recovery image * 2T2R 2.4 GHz Wi-Fi (11n) * 2T2R 5 GHz Wi-Fi (11ac) * 4x GPIO-LEDs (3x wifi, 1x power) * 1x GPIO-button (reset) * external h/w watchdog (enabled by default)) * TTL pins are on board (arrow points to VCC, then follows: GND, TX, RX) * TI tmp423 (package kmod-hwmon-tmp421) for temperature monitoring * 2x ethernet - eth0 + AR8035 ethernet PHY (RGMII) + 10/100/1000 Mbps Ethernet + 802.3af POE + used as LAN interface - eth1 + AR8031 ethernet PHY (RGMII) + 10/100/1000 Mbps Ethernet + 18-24V passive POE (mode B) + used as WAN interface * 12-24V 1A DC * internal antennas This device support is based on the partially working stub from commit 53c474abbd ("ath79: add new OF only target for QCA MIPS silicon"). Flashing instructions: ====================== Various methods can be used to install the actual image on the flash. Two easy ones are: ap51-flash ---------- The tool ap51-flash (https://github.com/ap51-flash/ap51-flash) should be used to transfer the image to the u-boot when the device boots up. initramfs from TFTP ------------------- The serial console must be used to access the u-boot shell during bootup. It can then be used to first boot up the initramfs image from a TFTP server (here with the IP 192.168.1.21): setenv serverip 192.168.1.21 setenv ipaddr 192.168.1.1 tftpboot 0c00000 <filename-of-initramfs-kernel>.bin && bootm $fileaddr The actual sysupgrade image can then be transferred (on the LAN port) to the device via scp <filename-of-squashfs-sysupgrade>.bin root@192.168.1.1:/tmp/ On the device, the sysupgrade must then be started using sysupgrade -n /tmp/<filename-of-squashfs-sysupgrade>.bin Signed-off-by: Sven Eckelmann <sven@narfation.org>		2022-01-16 20:51:14 +01:00
..
base-files/etc/hotplug.d/ieee80211	ath79: add WiFi migration for AR913x	2020-09-28 16:23:03 +02:00
dts	ath79: Add support for OpenMesh OM5P-AC v2	2022-01-16 20:51:14 +01:00
files	ath79: remove pre-5.10 specific kernel code	2021-12-29 03:44:56 +01:00
generic	ath79: Add support for OpenMesh OM5P-AC v2	2022-01-16 20:51:14 +01:00
image	ath79: Add support for OpenMesh OM5P-AC v2	2022-01-16 20:51:14 +01:00
mikrotik	mikrotik: enable variable size erase	2022-01-13 09:33:29 +01:00
nand	ath79: add support for Netgear R6100	2021-11-03 12:45:40 +01:00
patches-5.10	kernel: 5.10: add patches to fix macronix flash	2021-12-29 22:55:16 +01:00
tiny	ath79: consolidate testing kernel	2021-04-10 19:28:04 +02:00
config-5.10	kernel: filter out both Clang and LLD versions	2021-12-17 16:16:34 +01:00
Makefile	ath79: switch to Kernel 5.10	2021-12-21 21:38:52 +01:00
modules.mk