mirror of
https://github.com/openwrt/openwrt.git
synced 2025-01-11 15:33:03 +00:00
ddd809f9e5
This is the bcm57xx package. I have tested default vlan functions, but I dont have the equipment to test more advanced setups. The default vlan setup seems to be working fine. I also added the activate_gpio parameter which will make the driver activate the switch via gpio before probing for it. I'm not sure which method is best for autoload. For the wrt350n, I need the activate_gpio parameter. But its probably not a good idea to add that to the autoload file. On a system without a bcm57xx switch, isn't it a bad idea to mess with the gpios looking for the switch? Ideally, wouldn't it be best to load the bcm57xx module from broadcom-diag, after it has determined which router its on? I tried using 'request_module' from there, but had no success. For now, I am relying on preinit to load the bcm57xx module with activate_gpio param, after it has failed to load switch_robo and switch_adm. Signed-off-by: Ben Pfountz <netprince (at) vt (dot) edu> SVN-Revision: 11471
26 lines
792 B
C
26 lines
792 B
C
/*
|
|
* Misc system wide parameters.
|
|
*
|
|
* Copyright 2007, Broadcom Corporation
|
|
* All Rights Reserved.
|
|
*
|
|
* THIS SOFTWARE IS OFFERED "AS IS", AND BROADCOM GRANTS NO WARRANTIES OF ANY
|
|
* KIND, EXPRESS OR IMPLIED, BY STATUTE, COMMUNICATION OR OTHERWISE. BROADCOM
|
|
* SPECIFICALLY DISCLAIMS ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS
|
|
* FOR A SPECIFIC PURPOSE OR NONINFRINGEMENT CONCERNING THIS SOFTWARE.
|
|
* $Id: bcmparams.h,v 1.1.1.5 2007/05/31 08:00:41 michael Exp $
|
|
*/
|
|
|
|
#ifndef _bcmparams_h_
|
|
#define _bcmparams_h_
|
|
|
|
#define VLAN_MAXVID 15 /* Max. VLAN ID supported/allowed */
|
|
|
|
#define VLAN_NUMPRIS 8 /* # of prio, start from 0 */
|
|
|
|
#define DEV_NUMIFS 16 /* Max. # of devices/interfaces supported */
|
|
|
|
#define WL_MAXBSSCFG 16 /* maximum number of BSS Configs we can configure */
|
|
|
|
#endif
|