openwrt/target/linux
Hans Geiblinger 738e60be70 ipq40xx: Add support for Linksys MR8300 (Dallas)
The Linksys MR8300 is based on QCA4019 and QCA9888
and provides three, independent radios.
NAND provides two, alternate kernel/firmware images
with fail-over provided by the OEM U-Boot.

Hardware Highlights:

SoC: IPQ4019 at 717 MHz (4 CPUs)
RAM: 512MB RAM

SoC:	Qualcomm IPQ4019 at 717 MHz (4 CPUs)
RAM:	512M DDR3
FLASH:	256 MB NAND (Winbond W29N02GV, 8-bit parallel)
ETH:	Qualcomm QCA8075 (4x GigE LAN, 1x GigE Internet Ethernet Jacks)
BTN:	Reset and WPS
USB:	USB3.0, single port on rear with LED
SERIAL:	Serial pads internal (unpopulated)
LED:	Four status lights on top + USB LED
WIFI1:	2x2:2 QCA4019 2.4 GHz radio on ch. 1-14
WIFI2:  2x2:2 QCA4019 5 GHz radio on ch. 36-64
WIFI3:  2x2:2 QCA9888 5 GHz radio on ch. 100-165

Support is based on the already supported EA8300.
Key differences:
	EA8300 has 256MB RAM where MR8300 has 512MB RAM.
	MR8300 has a revised top panel LED setup.

Installation:
"Factory" images may be installed directly through the OEM GUI using
URL: https://ip-of-router/fwupdate.html (Typically 192.168.1.1)

Signed-off-by: Hans Geiblinger <cybrnook2002@yahoo.com>
[copied Hardware-highlights from EA8300. Fixed alphabetical order.
fixed commit subject, removed bogus unit-address of keys,
fixed author (used Signed-off-By to From:) ]
Signed-off-by: Christian Lamparter <chunkeey@gmail.com>
Signed-off-by: maurerr <mariusd84@gmail.com>
2021-09-01 08:07:01 +00:00
..
apm821xx treewide: remove empty default cases 2021-09-01 08:07:00 +00:00
arc770 arc770: drop support for kernel 4.14 2021-09-01 08:06:56 +00:00
archs38 treewide: use wpad-basic-wolfssl as default 2021-09-01 08:06:52 +00:00
armvirt kernel: set WATCHDOG_CORE dependency in kmod-hwmon-sch5627 2021-09-01 08:06:53 +00:00
at91 at91: explicitly set CONFIG_USB_SUPPORT for sam9x subtarget 2021-09-01 08:06:54 +00:00
ath25 ath25: fix preinit Ethernet port configuration 2021-09-01 08:06:58 +00:00
ath79 target: update SPDX license names 2021-09-01 08:07:01 +00:00
bcm27xx kernel: bump 5.4 to 5.4.67 2021-09-01 08:07:01 +00:00
bcm47xx kernel: bump 5.4 to 5.4.64 2021-09-01 08:06:58 +00:00
bcm53xx treewide: use wpad-basic-wolfssl as default 2021-09-01 08:06:52 +00:00
bcm63xx kernel: bump 5.4 to 5.4.67 2021-09-01 08:07:01 +00:00
gemini gemini: Add swap partition to DNS-313 2020-07-31 18:34:40 +02:00
generic kernel: bump 5.4 to 5.4.67 2021-09-01 08:07:01 +00:00
imx6 kernel: unify CONFIG_GPIO_SYSFS in kernel configs 2020-08-06 12:37:04 +02:00
ipq40xx ipq40xx: Add support for Linksys MR8300 (Dallas) 2021-09-01 08:07:01 +00:00
ipq806x ipq806x: fix support of Edgecore ECW5410 support 2021-09-01 08:07:00 +00:00
ipq807x kernel: unify CONFIG_GPIO_SYSFS in kernel configs 2020-08-06 12:37:04 +02:00
kirkwood target: update SPDX license names 2021-09-01 08:07:01 +00:00
lantiq kernel: bump 5.4 to 5.4.67 2021-09-01 08:07:01 +00:00
layerscape kernel: bump 5.4 to 5.4.67 2021-09-01 08:07:01 +00:00
malta kernel: set WATCHDOG_CORE dependency in kmod-hwmon-sch5627 2021-09-01 08:06:53 +00:00
mediatek kernel: bump 5.4 to 5.4.67 2021-09-01 08:07:01 +00:00
mpc85xx target: update SPDX license names 2021-09-01 08:07:01 +00:00
mvebu target: update SPDX license names 2021-09-01 08:07:01 +00:00
mxs treewide: make dependency on kmod-usb-net selective 2021-09-01 08:06:49 +00:00
octeon octeon: add support for Itus Shield Router 2021-09-01 08:06:51 +00:00
octeontx kernel: bump 5.4 to 5.4.60 2021-09-01 08:06:53 +00:00
omap treewide: use wpad-basic-wolfssl as default 2021-09-01 08:06:52 +00:00
oxnas target: update SPDX license names 2021-09-01 08:07:01 +00:00
pistachio pistachio: drop support for kernel 4.14 2021-09-01 08:06:56 +00:00
ramips ramips: add support for Linksys EA7300 v2 2021-09-01 08:07:01 +00:00
rockchip kernel: bump 5.4 to 5.4.58 2021-09-01 08:06:51 +00:00
rtl838x target: update SPDX license names 2021-09-01 08:07:01 +00:00
sunxi treewide: use wpad-basic-wolfssl as default 2021-09-01 08:06:52 +00:00
tegra treewide: use wpad-basic-wolfssl as default 2021-09-01 08:06:52 +00:00
uml uml: update to linux 5.4 2021-09-01 08:06:52 +00:00
x86 kernel: bump 5.4 to 5.4.63 2021-09-01 08:06:57 +00:00
zynq kernel: unify CONFIG_GPIO_SYSFS in kernel configs 2020-08-06 12:37:04 +02:00
Makefile build: add 'make kernel_xconfig' command 2020-07-08 16:07:05 +02:00