Tim Noack 0b4d831886 ath79: add support for TP-Link CPE710-v2 ... TP-Link CPE710-v2 is an outdoor wireless CPE for 5 GHz with one Ethernet port based on the AP152 reference board. Compared to the CPE710-v1, the only change observed in hardware is that the mdio address of the ethernet physical changed from 0x4 to 0x0. Specifications: - SoC: QCA9563-AL3A MIPS 74kc @ 775MHz, AHB @ 258MHz - RAM: 128MiB DDR2 @ 650MHz - Flash: 16MiB SPI NOR Based on the GD25Q128 - Wi-Fi 5Ghz: ath10k chip (802.11ac for up to 867Mbps on 5GHz wireless data rate), based on the QCA9896 - Ethernet: one 1GbE port - 23dBi high-gain directional 2×2 MIMO parabolic antenna - Power, LAN, WLAN5G Blue LEDs Flashing instructions: Flash factory image through stock firmware WEB UI or through TFTP To get to TFTP recovery just hold reset button while powering on for around 30-40 seconds and release. Rename factory image to recovery.bin Stock TFTP server IP:192.168.0.100 Stock device TFTP address:192.168.0.254 Signed-off-by: Tim Noack <tim@noack.id> Link: https://github.com/openwrt/openwrt/pull/16637 Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> (cherry picked from commit 5572e0196a) Link: https://github.com/openwrt/openwrt/pull/17097 Signed-off-by: Petr Štetiar <ynezz@true.cz>		2024-11-28 18:49:03 +00:00
..
imagebuilder	imagebuilder: fix OPKG package_whatdepends support	2024-11-20 09:49:57 +01:00
linux	ath79: add support for TP-Link CPE710-v2	2024-11-28 18:49:03 +00:00
llvm-bpf	build: use zstd for IB, toolchain, SDK and LLVM compression	2024-04-13 08:05:04 +02:00
sdk	sdk: bundle libraries for llvm toolchain	2024-10-19 20:43:54 +02:00
toolchain	build: use zstd for IB, toolchain, SDK and LLVM compression	2024-04-13 08:05:04 +02:00
Config.in	loongarch64: new target	2024-05-04 14:14:16 +08:00
Makefile	build: add $(STAGING_DIR) and $(BIN_DIR) preparation to target and package subdir compile dependencies	2024-03-03 23:13:59 +01:00