openwrt/target/linux
Sven Eckelmann 0b20490207 ipq40xx: add support for OpenMesh A62
* QCA IPQ4019
* 256 MB of RAM
* 32 MB of SPI NOR flash (s25fl256s1)
  - 2x 15 MB available; but one of the 15 MB regions is the recovery image
* 2T2R 2.4 GHz
  - QCA4019 hw1.0 (SoC)
  - requires special BDF in QCA4019/hw1.0/board-2.bin with
    bus=ahb,bmi-chip-id=0,bmi-board-id=20,variant=OM-A62
* 2T2R 5 GHz (channel 36-64)
  - QCA9888 hw2.0 (PCI)
  - requires special BDF in QCA9888/hw2.0/board-2.bin
    bus=pci,bmi-chip-id=0,bmi-board-id=16,variant=OM-A62
* 2T2R 5 GHz (channel 100-165)
  - QCA4019 hw1.0 (SoC)
  - requires special BDF in QCA4019/hw1.0/board-2.bin with
    bus=ahb,bmi-chip-id=0,bmi-board-id=21,variant=OM-A62
* multi-color LED (controlled via red/green/blue GPIOs)
* 1x button (reset; kmod-input-gpio-keys compatible)
* external watchdog
  - triggered GPIO
* 1x USB (xHCI)
* TTL pins are on board (arrow points to VCC, then follows: GND, TX, RX)
* 2x gigabit ethernet
  - phy@mdio3:
    + Label: Ethernet 1
    + gmac0 (ethaddr) in original firmware
    + 802.3at POE+
  - phy@mdio4:
    + Label: Ethernet 2
    + gmac1 (eth1addr) in original firmware
    + 18-24V passive POE (mode B)
* powered only via POE

The tool ap51-flash (https://github.com/ap51-flash/ap51-flash) should be
used to transfer the factory image to the u-boot when the device boots up.

The initramfs image can be started using

  setenv bootargs 'loglevel=8 earlycon=msm_serial_dm,0x78af000 console=ttyMSM0,115200 mtdparts=spi0.0:256k(0:SBL1),128k(0:MIBIB),384k(0:QSEE),64k(0:CDT),64k(0:DDRPARAMS),64k(0:APPSBLENV),512k(0:APPSBL),64k(0:ART),64k(0:custom),64k(0:KEYS),15552k(inactive),15552k(inactive2)'
  tftpboot 0x84000000 openwrt-ipq40xx-openmesh_a62-initramfs-fit-uImage.itb
  set fdt_high 0x85000000
  bootm 0x84000000

Signed-off-by: Sven Eckelmann <sven.eckelmann@openmesh.com>
2018-04-23 22:07:22 +02:00
..
adm5120 treewide: remove obsolete sysupgrade watchdog kill 2018-02-16 14:44:02 +01:00
adm8668
apm821xx build: consolidate fake uImage header build commands 2018-04-20 20:58:52 +02:00
ar7 kernel: bump 4.9 to 4.9.82 2018-02-18 02:59:57 +01:00
ar71xx ar71xx: increase kernel partition size for CPE/WBS 210/510 2018-04-10 18:29:19 +02:00
arc770
archs38 kernel: bump 4.14 to 4.14.20 2018-02-18 02:59:48 +01:00
armvirt armvirt: Resync kernel configuration 2018-01-12 15:14:27 -08:00
at91 at91: fix image building with CONFIG_TARGET_MULTI_PROFILE 2018-02-14 15:47:16 +01:00
ath25 build: replace uses of OpenWrt with $(VERSION_DIST) 2018-02-05 10:15:53 +01:00
au1000 treewide: remove obsolete sysupgrade watchdog kill 2018-02-16 14:44:02 +01:00
bcm53xx kernel: bump 4.14 to 4.14.34 2018-04-16 00:22:57 +03:00
brcm47xx brcm47xx: backport upstream patches for Netgear WNR1000 V3 2018-04-23 13:33:09 +02:00
brcm63xx kernel: update kernel 4.9 to version 4.9.91 2018-03-31 16:31:26 +02:00
brcm2708 kernel: update kernel 4.9 to version 4.9.91 2018-03-31 16:31:26 +02:00
cns3xxx treewide: remove obsolete sysupgrade watchdog kill 2018-02-16 14:44:02 +01:00
gemini kernel: Update kernel 4.4 to 4.4.100 2017-11-25 19:48:39 +01:00
generic kernel: fix an issue with infinite stack traces on MIPS 2018-04-18 12:17:28 +02:00
imx6 kernel: generic: Move config option to generic 2018-03-02 21:32:19 +01:00
ipq40xx ipq40xx: add support for OpenMesh A62 2018-04-23 22:07:22 +02:00
ipq806x build: consolidate fake uImage header build commands 2018-04-20 20:58:52 +02:00
ixp4xx kernel: update kernel 4.9 to version 4.9.91 2018-03-31 16:31:26 +02:00
kirkwood kirkwood: fix initramfs boot warning on iconnect 2018-03-20 21:45:27 +01:00
lantiq build: consolidate fake uImage header build commands 2018-04-20 20:58:52 +02:00
layerscape kernel: update kernel 4.9 to version 4.9.91 2018-03-31 16:31:26 +02:00
malta malta: bump tp v4.14 2018-01-09 10:26:16 +01:00
mcs814x build: replace uses of OpenWrt with $(VERSION_DIST) 2018-02-05 10:15:53 +01:00
mediatek mediatek: disable ubifs 2018-04-20 10:03:38 +02:00
mpc85xx build: consolidate fake uImage header build commands 2018-04-20 20:58:52 +02:00
mvebu mvebu: drop linux 4.4 and 4.9 support 2018-04-19 14:38:36 +02:00
mxs mxs: drop support for 4.9 2018-02-20 13:25:00 +01:00
octeon octeon: switch to kernel 4.14 2018-02-08 19:04:38 +01:00
octeontx octeontx: use the generic board detection 2018-02-23 08:21:50 +01:00
omap omap: remove linux 4.4 support 2018-04-19 14:38:53 +02:00
omap24xx omap24xx: remove referece to not existing kmod-usb-musb-tusb6010 2018-01-15 13:13:34 +01:00
orion orion: remove linux 4.4 support 2018-04-19 14:38:57 +02:00
oxnas kernel: bump 4.4 to 4.4.119 2018-03-03 12:58:56 +01:00
pistachio kernel: bump 4.14 to 4.14.34 2018-04-16 00:22:57 +03:00
ppc40x
ppc44x
ramips build: consolidate fake uImage header build commands 2018-04-20 20:58:52 +02:00
rb532 treewide: move nand_do_upgrade call to platform_do_upgrade 2018-02-16 14:44:02 +01:00
sunxi sunxi: add build for sopine 2018-03-23 23:53:20 +01:00
uml uml: Remove 4.4 patches 2018-03-08 11:44:26 -08:00
x86 x86: Use kernel 4.14 by default 2018-02-18 19:51:58 +01:00
xburst target: disable CONFIG_PROC_PAGE_MONITOR on most targets 2018-01-13 15:04:15 +01:00
zynq target: disable CONFIG_PROC_PAGE_MONITOR on most targets 2018-01-13 15:04:15 +01:00
Makefile