openwrt/target/linux/realtek/dts-5.10/rtl8380_netgear_gigabit.dtsi
Sander Vanheule c88124cfc4 realtek: netgear-gigabit: Enable RTL8231
Since the move to 5.10, there are now two GPIO drivers. The gpio0 node
refers to the internal GPIOs, so the indirect-access-bus-id is no longer
relevant for that node.

Set indirect-access-bus-id to the correct value (31) on the correct node
(gpio1) and enable the device.

Cc: Raylynn Knight <rayknight@me.com>
Cc: Michael Mohr <akihana@gmail.com>
Cc: Stijn Segers <foss@volatilesystems.org>
Cc: Stijn Tintel <stijn@linux-ipv6.be>
Signed-off-by: Sander Vanheule <sander@svanheule.net>
Tested-by: Bjørn Mork <bjorn@mork.no>
2021-12-27 13:51:41 +01:00

82 lines
1.3 KiB
Plaintext

// SPDX-License-Identifier: GPL-2.0-or-later
#include "rtl838x.dtsi"
#include <dt-bindings/input/input.h>
#include <dt-bindings/gpio/gpio.h>
/ {
compatible = "realtek,rtl838x-soc";
memory@0 {
device_type = "memory";
reg = <0x0 0x8000000>;
};
keys {
compatible = "gpio-keys";
mode {
label = "reset";
gpios = <&gpio0 0 GPIO_ACTIVE_LOW>;
linux,code = <KEY_RESTART>;
};
};
gpio-restart {
compatible = "gpio-restart";
gpios = <&gpio0 13 GPIO_ACTIVE_LOW>;
open-source;
};
};
&gpio1 {
status = "okay";
indirect-access-bus-id = <31>;
};
&ethernet0 {
mdio: mdio-bus {
compatible = "realtek,rtl838x-mdio";
regmap = <&ethernet0>;
#address-cells = <1>;
#size-cells = <0>;
INTERNAL_PHY(8)
INTERNAL_PHY(9)
INTERNAL_PHY(10)
INTERNAL_PHY(11)
INTERNAL_PHY(12)
INTERNAL_PHY(13)
INTERNAL_PHY(14)
INTERNAL_PHY(15)
};
};
&switch0 {
ports {
#address-cells = <1>;
#size-cells = <0>;
SWITCH_PORT(8, 1, internal)
SWITCH_PORT(9, 2, internal)
SWITCH_PORT(10, 3, internal)
SWITCH_PORT(11, 4, internal)
SWITCH_PORT(12, 5, internal)
SWITCH_PORT(13, 6, internal)
SWITCH_PORT(14, 7, internal)
SWITCH_PORT(15, 8, internal)
port@28 {
ethernet = <&ethernet0>;
reg = <28>;
phy-mode = "internal";
fixed-link {
speed = <1000>;
full-duplex;
};
};
};
};