openwrt/target/linux/bcm63xx/dts/bcm6328-comtrend-ar-5387un.dts
Adrian Schmutzler 026fe1308c bcm63xx: use generic diag.sh
This commit removes the target-specific diag.sh script. This way, the
generic one is used for the target, which uses DT-aliases to specify the
LEDs used.

Though generic diag.sh allows to use different LEDs to indicate different
states, this patch just moves the old assignment and does not try to
"improve" the assignment by using additional colors.
However, individual proposals to do so are welcome.

For the few cases where status_led2 was used in old diag.sh, only the
primary LED was migrated.

Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
2020-05-12 16:57:45 +02:00

105 lines
1.8 KiB
Plaintext

/dts-v1/;
#include "bcm6328.dtsi"
#include <dt-bindings/input/input.h>
/ {
model = "Comtrend AR-5387un";
compatible = "comtrend,ar-5387un", "brcm,bcm6328";
aliases {
led-boot = &led_power_green;
led-failsafe = &led_power_green;
led-running = &led_power_green;
led-upgrade = &led_power_green;
};
chosen {
bootargs = "rootfstype=squashfs,jffs2 noinitrd console=ttyS0,115200";
stdout-path = "serial0:115200n8";
};
keys {
compatible = "gpio-keys-polled";
#address-cells = <1>;
#size-cells = <0>;
poll-interval = <20>;
reset {
label = "reset";
gpios = <&pinctrl 23 1>;
linux,code = <KEY_RESTART>;
debounce-interval = <60>;
};
};
leds {
compatible = "gpio-leds";
inet_red {
label = "AR-5387un:red:inet";
gpios = <&pinctrl 1 0>;
};
power_red {
label = "AR-5387un:red:power";
gpios = <&pinctrl 4 0>;
};
inet_green {
label = "AR-5387un:green:inet";
gpios = <&pinctrl 7 0>;
};
led_power_green: power_green {
label = "AR-5387un:green:power";
gpios = <&pinctrl 8 0>;
default-state = "on";
};
dsl_green {
label = "AR-5387un:green:dsl";
gpios = <&pinctrl 11 1>;
};
};
};
&hsspi {
status = "ok";
flash@0 {
compatible = "jedec,spi-nor";
spi-max-frequency = <16666667>;
spi-tx-bus-width = <2>;
spi-rx-bus-width = <2>;
reg = <0>;
#address-cells = <1>;
#size-cells = <1>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
cfe@0 {
reg = <0x000000 0x010000>;
label = "cfe";
read-only;
};
linux@10000 {
reg = <0x010000 0xfe0000>;
label = "linux";
compatible = "brcm,bcm963xx-imagetag";
};
nvram@ff0000 {
reg = <0xff0000 0x010000>;
label = "nvram";
};
};
};
};
&uart0 {
status = "ok";
};