// SPDX-License-Identifier: GPL-2.0-or-later OR MIT #include "mt7628an.dtsi" #include #include / { compatible = "linksys,e5400", "mediatek,mt7628an-soc"; model = "Linksys E5400"; aliases { led-boot = &led_wps; led-failsafe = &led_wps; led-running = &led_wps; led-upgrade = &led_wps; label-mac-device = ðernet; }; chosen { bootargs = "console=ttyS0,115200"; }; memory@0 { device_type = "memory"; reg = <0x0 0x4000000>; }; keys { compatible = "gpio-keys"; reset { label = "reset"; gpios = <&gpio 11 GPIO_ACTIVE_LOW>; linux,code = ; }; wps { label = "wps"; gpios = <&gpio 38 GPIO_ACTIVE_LOW>; linux,code = ; }; }; leds { compatible = "gpio-leds"; led_wps: wps { label = "green:wps"; gpios = <&gpio 37 GPIO_ACTIVE_LOW>; }; }; }; &spi0 { status = "okay"; flash@0 { compatible = "jedec,spi-nor"; reg = <0>; spi-max-frequency = <40000000>; partitions { compatible = "fixed-partitions"; #address-cells = <1>; #size-cells = <1>; partition@0 { label = "u-boot"; reg = <0x0 0x30000>; read-only; }; partition@30000 { label = "u-boot-env"; reg = <0x30000 0x10000>; read-only; }; factory: partition@40000 { compatible = "nvmem-cells"; label = "factory"; reg = <0x40000 0x10000>; #address-cells = <1>; #size-cells = <1>; read-only; eeprom_factory_0: eeprom@0 { reg = <0x0 0x400>; }; macaddr_factory_28: macaddr@28 { reg = <0x28 0x6>; }; }; partition@50000 { compatible = "denx,uimage"; label = "firmware"; reg = <0x50000 0xfa0000>; }; partition@ff0000 { label = "cbtinfo"; reg = <0xff0000 0x10000>; read-only; }; }; }; }; &ehci { status = "disabled"; }; &esw { mediatek,portmap = <0x2f>; mediatek,portdisable = <0x20>; }; ðernet { nvmem-cells = <&macaddr_factory_28>; nvmem-cell-names = "mac-address"; }; &ohci { status = "disabled"; }; &pcie { status = "okay"; }; &pcie0 { wifi5: wifi@0,0 { compatible = "mediatek,mt76"; reg = <0x0000 0 0 0 0>; mediatek,mtd-eeprom = <&factory 0x8000>; ieee80211-freq-limit = <5000000 6000000>; nvmem-cells = <&macaddr_factory_28>; nvmem-cell-names = "mac-address"; mac-address-increment = <3>; }; }; &state_default { gpio { group = "gpio", "i2c", "i2s", "refclk", "uart1", "wdt", "wled_an"; function = "gpio"; }; }; &usbphy { status = "disabled"; }; &wmac { status = "okay"; nvmem-cells = <&eeprom_factory_0>, <&macaddr_factory_28>; nvmem-cell-names = "eeprom", "mac-address"; mac-address-increment = <2>; };