// SPDX-License-Identifier: (GPL-2.0 OR MIT) /dts-v1/; #include #include #include "mt7986a.dtsi" / { model = "Xiaomi Redmi Router AX6000"; compatible = "xiaomi,redmi-router-ax6000", "mediatek,mt7986a"; aliases { serial0 = &uart0; }; chosen { stdout-path = "serial0:115200n8"; }; memory { reg = <0 0x40000000 0 0x20000000>; }; keys { compatible = "gpio-keys"; reset { label = "reset"; gpios = <&pio 9 GPIO_ACTIVE_LOW>; linux,code = ; }; mesh { label = "mesh"; gpios = <&pio 10 GPIO_ACTIVE_LOW>; linux,code = ; linux,input-type = ; }; }; }; ð { status = "okay"; gmac0: mac@0 { compatible = "mediatek,eth-mac"; reg = <0>; phy-mode = "2500base-x"; nvmem-cells = <&macaddr_factory_4>; nvmem-cell-names = "mac-address"; mac-address-increment = <(-1)>; fixed-link { speed = <2500>; full-duplex; pause; }; }; mdio: mdio-bus { #address-cells = <1>; #size-cells = <0>; }; }; &mdio { switch: switch@0 { compatible = "mediatek,mt7531"; reg = <31>; reset-gpios = <&pio 5 GPIO_ACTIVE_HIGH>; interrupt-controller; #interrupt-cells = <1>; interrupt-parent = <&pio>; interrupts = <66 IRQ_TYPE_LEVEL_HIGH>; }; }; &pio { spi_flash_pins: spi-flash-pins-33-to-38 { mux { function = "spi"; groups = "spi0", "spi0_wp_hold"; }; conf-pu { pins = "SPI2_CS", "SPI2_HOLD", "SPI2_WP"; drive-strength = <8>; mediatek,pull-up-adv = <0>; /* bias-disable */ }; conf-pd { pins = "SPI2_CLK", "SPI2_MOSI", "SPI2_MISO"; drive-strength = <8>; mediatek,pull-down-adv = <0>; /* bias-disable */ }; }; wf_2g_5g_pins: wf_2g_5g-pins { mux { function = "wifi"; groups = "wf_2g", "wf_5g"; }; conf { pins = "WF0_HB1", "WF0_HB2", "WF0_HB3", "WF0_HB4", "WF0_HB0", "WF0_HB0_B", "WF0_HB5", "WF0_HB6", "WF0_HB7", "WF0_HB8", "WF0_HB9", "WF0_HB10", "WF0_TOP_CLK", "WF0_TOP_DATA", "WF1_HB1", "WF1_HB2", "WF1_HB3", "WF1_HB4", "WF1_HB0", "WF1_HB5", "WF1_HB6", "WF1_HB7", "WF1_HB8", "WF1_TOP_CLK", "WF1_TOP_DATA"; drive-strength = <4>; }; }; }; &spi0 { pinctrl-names = "default"; pinctrl-0 = <&spi_flash_pins>; cs-gpios = <0>, <0>; status = "okay"; flash@0 { compatible = "spi-nand"; #address-cells = <1>; #size-cells = <1>; reg = <0>; mediatek,nmbm; mediatek,bmt-max-ratio = <1>; mediatek,bmt-max-reserved-blocks = <64>; spi-max-frequency = <20000000>; spi-tx-buswidth = <4>; spi-rx-buswidth = <4>; partitions { compatible = "fixed-partitions"; #address-cells = <1>; #size-cells = <1>; partition@0 { label = "BL2"; reg = <0x0 0x100000>; read-only; }; partition@100000 { label = "Nvram"; reg = <0x100000 0x40000>; }; partition@140000 { label = "Bdata"; reg = <0x140000 0x40000>; }; factory: partition@180000 { label = "Factory"; reg = <0x180000 0x200000>; read-only; compatible = "nvmem-cells"; #address-cells = <1>; #size-cells = <1>; macaddr_factory_4: macaddr@4 { reg = <0x4 0x6>; }; }; partition@380000 { label = "FIP"; reg = <0x380000 0x200000>; read-only; }; partition@580000 { label = "crash"; reg = <0x580000 0x40000>; read-only; }; partition@5c0000 { label = "crash_log"; reg = <0x5c0000 0x40000>; read-only; }; /* ubi partition is the result of squashing * consecutive stock partitions: * - ubi * - ubi1 * - overlay */ partition@600000 { label = "ubi"; reg = <0x600000 0x6e00000>; }; /* last 12 MiB is reserved for NMBM bad block table */ }; }; }; &switch { ports { #address-cells = <1>; #size-cells = <0>; port@1 { reg = <1>; label = "lan4"; }; port@2 { reg = <2>; label = "lan3"; }; port@3 { reg = <3>; label = "lan2"; }; port@4 { reg = <4>; label = "wan"; }; port@6 { reg = <6>; label = "cpu"; ethernet = <&gmac0>; phy-mode = "2500base-x"; fixed-link { speed = <2500>; full-duplex; pause; }; }; }; }; &wmac { status = "okay"; pinctrl-names = "default"; pinctrl-0 = <&wf_2g_5g_pins>; mediatek,mtd-eeprom = <&factory 0x0>; }; &uart0 { status = "okay"; };