#include "rt2880.dtsi" #include #include #include / { compatible = "airlink101,ar670w", "ralink,rt2880-soc"; model = "Airlink101 AR670W"; aliases { led-boot = &led_power; led-failsafe = &led_power; led-running = &led_power; led-upgrade = &led_power; }; flash@bdc00000 { compatible = "cfi-flash"; reg = <0xbc400000 0x800000>; bank-width = <2>; partitions { compatible = "fixed-partitions"; #address-cells = <1>; #size-cells = <1>; partition@0 { reg = <0x0 0x30000>; label = "u-boot"; read-only; }; factory: partition@30000 { reg = <0x30000 0x10000>; label = "factory"; read-only; nvmem-layout { compatible = "fixed-layout"; #address-cells = <1>; #size-cells = <1>; eeprom_factory_2000: eeprom@2000 { reg = <0x2000 0x200>; }; macaddr_factory_2004: macaddr@2004 { reg = <0x2004 0x6>; }; }; }; partition@40000 { compatible = "lzma"; reg = <0x40000 0x3c0000>; label = "firmware"; }; }; }; leds { compatible = "gpio-leds"; led_power: power { function = LED_FUNCTION_POWER; color = ; gpios = <&gpio0 7 GPIO_ACTIVE_LOW>; }; wpsblue { function = LED_FUNCTION_WPS; color = ; gpios = <&gpio0 13 GPIO_ACTIVE_LOW>; }; }; keys { compatible = "gpio-keys-polled"; poll-interval = <100>; wps { label = "wps"; gpios = <&gpio0 0 GPIO_ACTIVE_LOW>; linux,code = ; }; reset { label = "reset"; gpios = <&gpio0 9 GPIO_ACTIVE_LOW>; linux,code = ; }; }; }; &state_default { gpio { groups = "i2c", "spi", "uartlite"; function = "gpio"; }; }; ðernet { status = "okay"; nvmem-cells = <&macaddr_factory_2004>; nvmem-cell-names = "mac-address"; port@0 { phy-handle = <&phy0>; phy-mode = "mii"; }; mdio-bus { status = "okay"; phy0: ethernet-phy@0 { phy-mode = "mii"; reg = <0>; }; }; }; &wmac { nvmem-cells = <&eeprom_factory_2000>; nvmem-cell-names = "eeprom"; };