// SPDX-License-Identifier: GPL-2.0-or-later OR MIT #include "qca955x.dtsi" #include #include / { compatible = "ocedo,ursus", "qca,qca9558"; model = "OCEDO Ursus"; leds { compatible = "gpio-leds"; wifi2 { label = "green:wlan2g"; gpios = <&gpio 14 GPIO_ACTIVE_LOW>; linux,default-trigger = "phy1tpt"; }; wifi5 { label = "green:wlan5g"; gpios = <&gpio 15 GPIO_ACTIVE_LOW>; linux,default-trigger = "phy0tpt"; }; }; }; &pcie1 { status = "okay"; wifi@0,0 { compatible = "qcom,ath10k"; reg = <0x0000 0 0 0 0>; nvmem-cells = <&cal_art_5000>, <&macaddr_art_c>; nvmem-cell-names = "calibration", "mac-address"; }; }; &spi { status = "okay"; flash@0 { compatible = "jedec,spi-nor"; reg = <0>; spi-max-frequency = <50000000>; partitions { compatible = "fixed-partitions"; #address-cells = <1>; #size-cells = <1>; uboot: partition@0 { label = "u-boot"; reg = <0x000000 0x040000>; read-only; }; partition@40000 { label = "u-boot-env"; reg = <0x040000 0x010000>; }; partition@50000 { /* Dual-Flash layout combined */ compatible = "denx,uimage"; label = "firmware"; reg = <0x050000 0xe80000>; }; partition@ed0000 { label = "data"; reg = <0xed0000 0x110000>; read-only; }; partition@fe0000 { label = "id"; reg = <0xfe0000 0x010000>; read-only; }; partition@ff0000 { label = "art"; reg = <0xff0000 0x010000>; read-only; nvmem-layout { compatible = "fixed-layout"; #address-cells = <1>; #size-cells = <1>; macaddr_art_0: macaddr@0 { reg = <0x0 0x6>; }; macaddr_art_6: macaddr@6 { reg = <0x6 0x6>; }; macaddr_art_c: macaddr@c { reg = <0xc 0x6>; }; macaddr_art_12: macaddr@12 { reg = <0x12 0x6>; }; cal_art_1000: calibration@1000 { reg = <0x1000 0x440>; }; cal_art_5000: calibration@5000 { reg = <0x5000 0x844>; }; }; }; }; }; }; &wmac { status = "okay"; nvmem-cells = <&macaddr_art_6>, <&cal_art_1000>; nvmem-cell-names = "mac-address", "calibration"; }; &mdio0 { status = "okay"; phy1: ethernet-phy@1 { reg = <1>; }; phy2: ethernet-phy@2 { reg = <2>; at803x-override-sgmii-link-check; }; }; ð0 { status = "okay"; nvmem-cells = <&macaddr_art_0>; nvmem-cell-names = "mac-address"; phy-mode = "rgmii-rxid"; phy-handle = <&phy1>; pll-data = <0x8e000000 0x80000101 0x80001313>; gmac_config: gmac-config { device = <&gmac>; rxdv-delay = <3>; rxd-delay = <3>; txen-delay = <0>; txd-delay = <0>; rgmii-enabled = <1>; }; }; ð1 { status = "okay"; nvmem-cells = <&macaddr_art_12>; nvmem-cell-names = "mac-address"; phy-handle = <&phy2>; pll-data = <0x3000101 0x101 0x1313>; qca955x-sgmii-fixup; };