From 4468993bd62bfd84b5c7e9004b06cb2c7902f1c3 Mon Sep 17 00:00:00 2001 From: Phil Elwell Date: Mon, 8 Jan 2024 08:45:21 +0000 Subject: [PATCH 0820/1085] ARM: dts: bcm2712-rpi-5-b: Use common LED labels As of 6.6, the names of the labels on the Pi LEDs was swapped to match the upstream code, i.e. led_act rather than act_led. Apply the same change to Pi 5. Signed-off-by: Phil Elwell --- arch/arm/boot/dts/broadcom/bcm2712-rpi-5-b.dts | 12 ++++++------ 1 file changed, 6 insertions(+), 6 deletions(-) --- a/arch/arm/boot/dts/broadcom/bcm2712-rpi-5-b.dts +++ b/arch/arm/boot/dts/broadcom/bcm2712-rpi-5-b.dts @@ -63,14 +63,14 @@ leds: leds { compatible = "gpio-leds"; - pwr_led: led-pwr { + led_pwr: led-pwr { label = "PWR"; gpios = <&rp1_gpio 44 GPIO_ACTIVE_LOW>; default-state = "off"; linux,default-trigger = "none"; }; - act_led: led-act { + led_act: led-act { label = "ACT"; gpios = <&gio_aon 9 GPIO_ACTIVE_LOW>; default-state = "off"; @@ -826,10 +826,10 @@ spi10_cs_pins: &spi10_cs_gpio1 {}; uart0 = <&uart0>, "status"; wifiaddr = <&wifi>, "local-mac-address["; - act_led_activelow = <&act_led>, "active-low?"; - act_led_trigger = <&act_led>, "linux,default-trigger"; - pwr_led_activelow = <&pwr_led>, "gpios:8"; - pwr_led_trigger = <&pwr_led>, "linux,default-trigger"; + act_led_activelow = <&led_act>, "active-low?"; + act_led_trigger = <&led_act>, "linux,default-trigger"; + pwr_led_activelow = <&led_pwr>, "gpios:8"; + pwr_led_trigger = <&led_pwr>, "linux,default-trigger"; eth_led0 = <&phy1>,"led-modes:0"; eth_led1 = <&phy1>,"led-modes:4"; drm_fb0_rp1_dsi0 = <&aliases>, "drm-fb0=",&dsi0;