mirror of
https://github.com/openwrt/openwrt.git
synced 2024-12-23 15:32:33 +00:00
ath79: add support for ASUS RP-AC66
Asus RP-AC66 Repeater
Hardware specifications:
Board: AP152
SoC: QCA9563
DRAM: 64MB DDR2
Flash: 25l128 16MB SPI-NOR
LAN/WAN: 1x1000M QCA8033
WiFi 5GHz: QCA9880
Clocks: CPU:775.000MHz, DDR:650.000MHz, AHB:258.333MHz, Ref:25.000MHz
MAC addresses as verified by OEM firmware:
use address source
Lan/Wan *:24 art 0x1002 (label)
2G *:24 art 0x1002
5G *:26 art 0x5006
Installation:
Asus windows recovery tool:
- install the Asus firmware restoration utility
- unplug the router, hold the reset button while powering it on
- release when the power LED flashes slowly
- specify a static IP on your computer:
IP address: 192.168.1.75
Subnet mask 255.255.255.0
- Start the Asus firmware restoration utility, specify the factory image
and press upload
- Do not power off the device after OpenWrt has booted until the LED flashing.
TFTP Recovery method:
- set computer to a static ip, 192.168.1.75
- connect computer to the LAN 1 port of the router
- hold the reset button while powering on the router for a few seconds
- send firmware image using a tftp client; i.e from linux:
$ tftp
tftp> binary
tftp> connect 192.168.1.1
tftp> put factory.bin
tftp> quit
Signed-off-by: Tamas Balogh <tamasbalogh@hotmail.com>
This commit is contained in:
Tamas Balogh
Hauke Mehrtens
parent
0f50d3daff
commit
b29f4cf34c
158
target/linux/ath79/dts/qca9563_asus_rp-ac66.dts
Normal file
158
target/linux/ath79/dts/qca9563_asus_rp-ac66.dts
Normal file
@ -0,0 +1,158 @@
|
||||
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
|
||||
|
||||
#include "qca956x.dtsi"
|
||||
|
||||
#include <dt-bindings/gpio/gpio.h>
|
||||
#include <dt-bindings/input/input.h>
|
||||
#include <dt-bindings/leds/common.h>
|
||||
|
||||
/ {
|
||||
model = "ASUS RP-AC66";
|
||||
compatible = "asus,rp-ac66", "qca,qca9563";
|
||||
|
||||
aliases {
|
||||
led-boot = &led_orange;
|
||||
led-failsafe = &led_orange;
|
||||
led-running = &led_power;
|
||||
led-upgrade = &led_orange;
|
||||
};
|
||||
|
||||
leds {
|
||||
compatible = "gpio-leds";
|
||||
|
||||
led_power: power {
|
||||
label = "green:power";
|
||||
gpios = <&gpio 6 GPIO_ACTIVE_HIGH>;
|
||||
};
|
||||
|
||||
led_orange: wps {
|
||||
label = "orange:wps";
|
||||
gpios = <&gpio 1 GPIO_ACTIVE_HIGH>;
|
||||
};
|
||||
|
||||
rssilow-wlan0 {
|
||||
label = "blue:rssilow-wlan0";
|
||||
gpios = <&gpio 14 GPIO_ACTIVE_HIGH>;
|
||||
};
|
||||
|
||||
rssimedium-wlan0 {
|
||||
label = "red:rssimedium-wlan0";
|
||||
gpios = <&gpio 16 GPIO_ACTIVE_HIGH>;
|
||||
};
|
||||
|
||||
rssihigh-wlan0 {
|
||||
label = "green:rssihigh-wlan0";
|
||||
gpios = <&gpio 15 GPIO_ACTIVE_HIGH>;
|
||||
};
|
||||
|
||||
rssilow-wlan1 {
|
||||
label = "blue:rssilow-wlan1";
|
||||
gpios = <&gpio 7 GPIO_ACTIVE_HIGH>;
|
||||
};
|
||||
|
||||
rssimedium-wlan1 {
|
||||
label = "red:rssimedium-wlan1";
|
||||
gpios = <&gpio 9 GPIO_ACTIVE_HIGH>;
|
||||
};
|
||||
|
||||
rssihigh-wlan1 {
|
||||
label = "green:rssihigh-wlan1";
|
||||
gpios = <&gpio 8 GPIO_ACTIVE_HIGH>;
|
||||
};
|
||||
};
|
||||
|
||||
keys {
|
||||
compatible = "gpio-keys";
|
||||
|
||||
wps {
|
||||
linux,code = <KEY_WPS_BUTTON>;
|
||||
gpios = <&gpio 5 GPIO_ACTIVE_LOW>;
|
||||
debounce-interval = <60>;
|
||||
};
|
||||
|
||||
reset {
|
||||
linux,code = <KEY_RESTART>;
|
||||
gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
|
||||
debounce-interval = <60>;
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
&pcie {
|
||||
status = "okay";
|
||||
};
|
||||
|
||||
&spi {
|
||||
status = "okay";
|
||||
|
||||
flash@0 {
|
||||
compatible = "jedec,spi-nor";
|
||||
reg = <0>;
|
||||
spi-max-frequency = <50000000>;
|
||||
|
||||
partitions {
|
||||
compatible = "fixed-partitions";
|
||||
#address-cells = <1>;
|
||||
#size-cells = <1>;
|
||||
|
||||
partition@0 {
|
||||
label = "u-boot";
|
||||
reg = <0x000000 0x40000>;
|
||||
read-only;
|
||||
};
|
||||
|
||||
partition@40000 {
|
||||
label = "u-boot-env";
|
||||
reg = <0x040000 0x10000>;
|
||||
read-only;
|
||||
};
|
||||
|
||||
art: partition@50000 {
|
||||
label = "art";
|
||||
reg = <0x050000 0x10000>;
|
||||
read-only;
|
||||
|
||||
compatible = "nvmem-cells";
|
||||
#address-cells = <1>;
|
||||
#size-cells = <1>;
|
||||
|
||||
macaddr_art_1002: macaddr@1002 {
|
||||
reg = <0x1002 0x6>;
|
||||
};
|
||||
};
|
||||
|
||||
partition@60000 {
|
||||
compatible = "denx,uimage";
|
||||
label = "firmware";
|
||||
reg = <0x060000 0xf20000>;
|
||||
};
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
&mdio0 {
|
||||
status = "okay";
|
||||
|
||||
phy-mask = <0>;
|
||||
|
||||
phy0: ethernet-phy@3 {
|
||||
reg = <0x3>;
|
||||
phy-mode = "sgmii";
|
||||
qca,mib-poll-interval = <500>;
|
||||
};
|
||||
};
|
||||
|
||||
ð0 {
|
||||
status = "okay";
|
||||
|
||||
phy-mode = "sgmii";
|
||||
nvmem-cells = <&macaddr_art_1002>;
|
||||
nvmem-cell-names = "mac-address";
|
||||
phy-handle = <&phy0>;
|
||||
};
|
||||
|
||||
&wmac {
|
||||
status = "okay";
|
||||
|
||||
qca,no-eeprom;
|
||||
};
|
||||
@ -48,6 +48,16 @@ alfa-network,r36a)
|
||||
ucidef_set_led_netdev "lan" "LAN" "blue:lan" "eth0"
|
||||
ucidef_set_led_switch "wan" "WAN" "blue:wan" "switch0" "0x10"
|
||||
;;
|
||||
asus,rp-ac66)
|
||||
ucidef_set_rssimon "wlan0" "200000" "1"
|
||||
ucidef_set_rssimon "wlan1" "200000" "1"
|
||||
ucidef_set_led_rssi "rssilow-wlan0" "RSSILOW" "blue:rssilow-wlan0" "wlan0" "1" "1"
|
||||
ucidef_set_led_rssi "rssimedium-wlan0" "RSSIMEDIUM" "red:rssimedium-wlan0" "wlan0" "1" "79"
|
||||
ucidef_set_led_rssi "rssihigh-wlan0" "RSSIHIGH" "green:rssihigh-wlan0" "wlan0" "70" "100"
|
||||
ucidef_set_led_rssi "rssilow-wlan1" "RSSILOW" "blue:rssilow-wlan1" "wlan1" "1" "1"
|
||||
ucidef_set_led_rssi "rssimedium-wlan1" "RSSIMEDIUM" "red:rssimedium-wlan1" "wlan1" "1" "79"
|
||||
ucidef_set_led_rssi "rssihigh-wlan1" "RSSIHIGH" "green:rssihigh-wlan1" "wlan1" "70" "100"
|
||||
;;
|
||||
avm,fritz1750e)
|
||||
ucidef_set_led_netdev "lan" "LAN" "green:lan" "eth0"
|
||||
ucidef_set_rssimon "wlan1" "200000" "1"
|
||||
|
||||
@ -15,6 +15,7 @@ ath79_setup_interfaces()
|
||||
alfa-network,pi-wifi4|\
|
||||
arduino,yun|\
|
||||
aruba,ap-105|\
|
||||
asus,rp-ac66|\
|
||||
avm,fritz1750e|\
|
||||
avm,fritz300e|\
|
||||
avm,fritzdvbc|\
|
||||
@ -533,6 +534,10 @@ ath79_setup_macs()
|
||||
lan_mac=$(macaddr_setbit $base_mac 29)
|
||||
[ $lan_mac = $base_mac ] && lan_mac=$(macaddr_unsetbit $base_mac 29)
|
||||
;;
|
||||
asus,rp-ac66)
|
||||
lan_mac=$(mtd_get_mac_binary art 0x1002)
|
||||
label_mac=$lan_mac
|
||||
;;
|
||||
avm,fritz1750e|\
|
||||
avm,fritz450e|\
|
||||
avm,fritzdvbc)
|
||||
|
||||
@ -12,6 +12,9 @@ case "$FIRMWARE" in
|
||||
8dev,lima)
|
||||
caldata_extract "art" 0x1000 0x800
|
||||
;;
|
||||
asus,rp-ac66)
|
||||
caldata_extract "art" 0x1000 0x440
|
||||
;;
|
||||
avm,fritz1750e|\
|
||||
avm,fritz4020|\
|
||||
avm,fritz450e|\
|
||||
|
||||
@ -21,6 +21,7 @@ case "$FIRMWARE" in
|
||||
avm,fritzdvbc)
|
||||
caldata_extract "urlader" 0x198a 0x844
|
||||
;;
|
||||
asus,rp-ac66|\
|
||||
comfast,cf-wr650ac-v1|\
|
||||
comfast,cf-wr650ac-v2|\
|
||||
devolo,dlan-pro-1200plus-ac|\
|
||||
|
||||
@ -330,6 +330,18 @@ define Device/aruba_ap-105
|
||||
endef
|
||||
TARGET_DEVICES += aruba_ap-105
|
||||
|
||||
define Device/asus_rp-ac66
|
||||
SOC := qca9563
|
||||
DEVICE_VENDOR := ASUS
|
||||
DEVICE_MODEL := RP-AC66
|
||||
IMAGES += factory.bin
|
||||
IMAGE/factory.bin := append-kernel | pad-to $$$$(BLOCKSIZE) | \
|
||||
append-rootfs | pad-rootfs
|
||||
DEVICE_PACKAGES := kmod-ath10k-ct-smallbuffers ath10k-firmware-qca988x-ct \
|
||||
rssileds -swconfig
|
||||
endef
|
||||
TARGET_DEVICES += asus_rp-ac66
|
||||
|
||||
define Device/atheros_db120
|
||||
$(Device/loader-okli-uimage)
|
||||
SOC := ar9344
|
||||
|
||||
Loading…
Reference in New Issue
Block a user