openwrt/target/linux/kirkwood/patches-5.4/105-ea4500.patch

--- a/arch/arm/boot/dts/kirkwood-linksys-viper.dts
+++ b/arch/arm/boot/dts/kirkwood-linksys-viper.dts
@@ -24,6 +24,10 @@
 	};
 
 	aliases {
+		led-boot = &led_white_health;
+		led-failsafe = &led_white_health;
+		led-running = &led_white_health;
+		led-upgrade = &led_white_health;
 		serial0 = &uart0;
 	};
 
@@ -56,9 +60,10 @@
 		pinctrl-0 = < &pmx_led_white_health &pmx_led_white_pulse >;
 		pinctrl-names = "default";
 
-		white-health {
+		led_white_health: white-health {
 			label = "viper:white:health";
 			gpios = <&gpio0 7 GPIO_ACTIVE_HIGH>;
+			default-state = "on";
 		};
 
 		white-pulse {
@@ -66,6 +71,17 @@
 			gpios = <&gpio0 14 GPIO_ACTIVE_HIGH>;
 		};
 	};
+
+	mvsw61xx@10 {
+		compatible = "marvell,88e6171";
+		status = "okay";
+		reg = <0x10>;
+
+		mii-bus = <&mdio>;
+		cpu-port-0 = <5>;
+		cpu-port-1 = <6>;
+		is-indirect;
+	};
 };
 
 &pinctrl {
@@ -114,22 +130,22 @@
 		};
 
 		partition@200000 {
-			label = "kernel";
+			label = "kernel1";
 			reg = <0x200000 0x2A0000>;
 		};
 
 		partition@4a0000 {
-			label = "rootfs";
+			label = "rootfs1";
 			reg = <0x4A0000 0x1760000>;
 		};
 
 		partition@1c00000 {
-			label = "alt_kernel";
+			label = "kernel2";
 			reg = <0x1C00000 0x2A0000>;
 		};
 
 		partition@1ea0000 {
-			label = "alt_rootfs";
+			label = "rootfs2";
 			reg = <0x1EA0000 0x1760000>;
 		};
 
@@ -162,6 +178,7 @@
 	status = "okay";
 
 	switch@10 {
+		status = "disabled";
 		compatible = "marvell,mv88e6085";
 		#address-cells = <1>;
 		#size-cells = <0>;
@@ -225,10 +242,14 @@
 };
 
 /* eth1 is connected to the switch at port 6. However DSA only supports a
- * single CPU port. So leave this port disabled to avoid confusion.
+ * single CPU port. Upstream uses DSA so they disable this port to avoid confusion.
  */
 &eth1 {
-	status = "disabled";
+	status = "okay";
+	ethernet1-port@0 {
+		speed = <1000>;
+		duplex = <1>;
+	};
 };
 
 /* There is no battery on the board, so the RTC does not keep