openwrt/target/linux/rockchip/image/nanopi-r2s.bootscript

part uuid mmc ${devnum}:2 uuid

setenv bootargs "console=ttyS2,1500000 earlycon=uart8250,mmio32,0xff130000 root=PARTUUID=${uuid} rw rootwait"

load mmc ${devnum}:1 ${kernel_addr_r} kernel.img

bootm ${kernel_addr_r}
rockchip: add NanoPi R2S support Hardware -------- RockChip RK3328 ARM64 (4 cores) 1GB DDR4 RAM 2x 1000 Base-T 3 LEDs (LAN / WAN / SYS) 1 Button (Reset) Micro-SD slot USB 2.0 Port Installation ------------ Uncompress the OpenWrt sysupgrade and write it to a micro SD card using dd. MAC-address ----------- The vendor code supports reading a MAC address from an EEPROM connected via i2c0 of the SoC. The EEPROM (address 0x51) should contain the MAC address in binary at offset 0xfa. However, my two units didn't come with such an EEPROM soldered on. The EEPROM should be placed between the SoC and the GPIO pins on the board. (U10) Generating rendom MAC addresses works around this issue. Otherwise, all boards running the same image have identical MAC addresses. Signed-off-by: David Bauer <mail@david-bauer.net> 2020-07-16 08:08:57 +00:00			`part uuid mmc ${devnum}:2 uuid`

			`setenv bootargs "console=ttyS2,1500000 earlycon=uart8250,mmio32,0xff130000 root=PARTUUID=${uuid} rw rootwait"`

			`load mmc ${devnum}:1 ${kernel_addr_r} kernel.img`

rockchip: use LZMA FIT for kernel image Use LZMA compressed kernel to save some space in boot partition. Fixes: #11197 Tested-by: Tianling Shen <cnsztl@immortalwrt.org> [NanoPi R2S] Signed-off-by: Chuanhong Guo <gch981213@gmail.com> 2022-11-13 13:29:26 +00:00			`bootm ${kernel_addr_r}`