openwrt/target/linux/ipq40xx/patches-4.14/088-0009-i2c-qup-change-completion-timeout-according-to-trans.patch

62 lines
2.0 KiB
Diff
Raw Normal View History

From ecb6e1e5f4352055a5761b945a833a925d51bf8d Mon Sep 17 00:00:00 2001
From: Abhishek Sahu <absahu@codeaurora.org>
Date: Mon, 12 Mar 2018 18:44:58 +0530
Subject: [PATCH 09/13] i2c: qup: change completion timeout according to
transfer length
Currently the completion timeout is being taken according to
maximum transfer length which is too high if SCL is operating in
high frequency. This patch calculates timeout on the basis of
one-byte transfer time and uses the same for completion timeout.
Signed-off-by: Abhishek Sahu <absahu@codeaurora.org>
Reviewed-by: Andy Gross <andy.gross@linaro.org>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>
---
drivers/i2c/busses/i2c-qup.c | 13 ++++++++++---
1 file changed, 10 insertions(+), 3 deletions(-)
--- a/drivers/i2c/busses/i2c-qup.c
+++ b/drivers/i2c/busses/i2c-qup.c
@@ -121,8 +121,12 @@
#define MX_TX_RX_LEN SZ_64K
#define MX_BLOCKS (MX_TX_RX_LEN / QUP_READ_LIMIT)
-/* Max timeout in ms for 32k bytes */
-#define TOUT_MAX 300
+/*
+ * Minimum transfer timeout for i2c transfers in seconds. It will be added on
+ * the top of maximum transfer time calculated from i2c bus speed to compensate
+ * the overheads.
+ */
+#define TOUT_MIN 2
/* Default values. Use these if FW query fails */
#define DEFAULT_CLK_FREQ 100000
@@ -163,6 +167,7 @@ struct qup_i2c_dev {
int in_blk_sz;
unsigned long one_byte_t;
+ unsigned long xfer_timeout;
struct qup_i2c_block blk;
struct i2c_msg *msg;
@@ -849,7 +854,7 @@ static int qup_i2c_bam_do_xfer(struct qu
dma_async_issue_pending(qup->brx.dma);
}
- if (!wait_for_completion_timeout(&qup->xfer, TOUT_MAX * HZ)) {
+ if (!wait_for_completion_timeout(&qup->xfer, qup->xfer_timeout)) {
dev_err(qup->dev, "normal trans timed out\n");
ret = -ETIMEDOUT;
}
@@ -1606,6 +1611,8 @@ nodma:
*/
one_bit_t = (USEC_PER_SEC / clk_freq) + 1;
qup->one_byte_t = one_bit_t * 9;
+ qup->xfer_timeout = TOUT_MIN * HZ +
+ usecs_to_jiffies(MX_TX_RX_LEN * qup->one_byte_t);
dev_dbg(qup->dev, "IN:block:%d, fifo:%d, OUT:block:%d, fifo:%d\n",
qup->in_blk_sz, qup->in_fifo_sz,