This commit introduces a C-API to the Uplink session, as well as to
serve as a Block service. It can be used by drivers ported from
C-only projects, like the Linux kernel, or BSD kernels for instance.
Fix#4226
This API rework eases the access to memory-mapped I/O registers and
interrupts when using the platform driver. It introduces the notions of
- Platform::Device - one device obtained from a platform session
- Platform::Device::Mmio - locally-mapped MMIO registers of a device
- Platform::Device::Irq - interface for receiving device interrupts
The patch touches several drivers. Some drivers would require a
significant structural change to adopt the new API (e.g., net/virtio,
dde_linux drivers, imx gpio). In these cases, the patch adds
compatibility shims meant to be temporary. In other cases (e.g., imx
i2c), the adaptation was simple enough to carry through.
Fixes#4075
In order to perform a smooth transition from NIC drivers that act only as NIC
session clients to NIC drivers that act only as Uplink session clients, this
commit introduces an intermediate state in which all NIC drivers support both
modes. That said, a NIC drivers mode is now statically determined through a new
optional 'mode' attribute in the drivers <config> tag that can be set to either
'nic_server' (default value) or 'uplink_client'. Reconfiguring this attribute
at a driver doesn't have any effects. Whithout this attribute being set, all
NIC drivers will behave the same as they did before the commit. When set to
'uplink_client', however, instead of providing a Nic service, they request
an Uplink session whenever their network interface becomes "UP" and close the
session whenever their network interface becomes "DOWN".
Ref #3961
Adds new Uplink session interface, the corresponding client side (Client,
Connection), and the corresponding API archives. An Uplink session is almost
the same as a NIC session with the difference that the roles of the end points
are swapped. An Uplink client is the one that provides a network interface
(for instance, a NIC driver) whereas an Uplink server is the one that uses
that network interface (for instance, a networking stack).
Therefore, in contrast to the NIC session, MAC address and link state come from
the Uplink client. The link state is reflected through the lifetime of an
Uplink session: The client requests the session only when the link state is
"UP" and closes it whenever the link state becomes "DOWN" again. The MAC
address is transmitted from the Uplink client to the Uplink server as an
argument of the session request.
Ref #3961
To simplify writing native VirtIO drivers for Genode add helper classes
representing VirtIO device and queue. The queue implementation should
be platform independant. The device abstraction however is closely tied
to the VirtIO transport being used (PCI/MMIO). Both PCI and MMIO
implementations expose the same public API so the actual driver logic
should be the same regardless of which transport is used.
Its also important to note that the PCI version of Virtio::Device
currently does not support MSI-X interrupts. Unfortunately my kowledge
about PCI bus is very limited and my main area of interest was to get
VirtIO drivers working on virt_qemu ARM/Aarch64 platform. As such all
the VirtIO drivers I plan to submit will work with PCI bus, but might
not use some extended capabilities.
Ref #3825
The blit API archive missed the CPU-architecture-specific variants of
the blit library such that all depot binaries worked with the generic
(slow) fallback implementation. This patch adds the missing pieces to
the blit API archive.
