Make them configurable, default to y when build!=host (i.e.
canadian or cross-native) because we don't know what libraries the host
will provide. GLIBC, as previously, selects them explicitly.
Signed-off-by: Alexey Neyman <stilor@att.net>
This follows the trend set by 1*.sh scripts that configure ISL, GMP,
MPFR, CLooG, etc. Building with shared libraries presents all kinds
of problems:
- The shared libraries need to be installed into ${CT_PREFIX_DIR}.
- The binaries linked against companion libs need to have proper
RPATH, or they're looking for shared libs in
.build/${CT_PREFIX}/buildtools/lib.
- All libraries must agree as to whether they're built shared,
static, or both. Otherwise, gettext tries to link in static libncurses.a
into a shared library and fails (since libncurses was compiled without
the -fPIC switch and hence contains relocations that cannot be handled
in a shared library).
So this fixes the current mess. If we decide to re-enable building
the companion libs shared, we should probably make this dependent on
a separate suboption of CT_STATIC_TOOLCHAIN.
Add a config loosely based on one reported in the issue 274.
Signed-off-by: Alexey Neyman <stilor@att.net>
In that case, CT_GetCustom just creates a symlink to the original.
In that case, 'cp -a <path> .' gives an error and 'cp -a <path> <newdir>'
creates <newdir> as a symlink (which will then run the build inside
the shared directory, .build/src/<package>).
Signed-off-by: Alexey Neyman <stilor@att.net>
The referenced commit replaced 'make' with '${make}' everywhere. This is
wrong for at least the utilities that we may build as companion tools
(make, libtool): this will always invoke the version detected by configure
by supplying the absolute path. In other words, the wrappers in
.build/tools/bin are not fallbacks - they are either temporary (in case
a respective companion tool is built) or permanent redirectors.
This is the reason why the PATH= has .build/*/buildtools/bin at higher
precedence than .build/tools/bin; the latter has the versions detected by
configure and the former has the versions built as companion tools.
Revert the rest of the gang (grep/sed/...) for consistency. After all,
we may decide to supply some of them as well (awk, for instance).
Signed-off-by: Alexey Neyman <stilor@att.net>
We check for apps:
* make
* sed
* grep
* awk
* libtool/libtoolize
* install
* patch
* and more
...during configure. Our scripts should be consistent about using the
variables that define where the found tool was found.
Of course, we do hard-link these tools in buildtools, but that should be
a backup for the components we are building. Our scripts should always
use the tools we find.
Signed-off-by: Bryan Hundven <bryanhundven@gmail.com>
.. they're needed for the RPC generation in glibc
on both Cygwin and MinGW-w64.
Neither are built on GNU/Linux and iconv is not
built on Darwin.
Two patches for gettext are needed, one so that
-O0 works and one so that static builds can be
made.
They can take a good while to build, so if not
needed for_host or for_build then they are not
built.
Signed-off-by: Ray Donnelly <mingw.android@gmail.com>
